Skip to main content
Lazervida Help Center Help Center home page Lazervida Help Center
  • Submit a request
  • Sign in
  • Sign in
  • Submit a request
  1. Lazervida Help Center
  2. Lazervida Guide

Lazervida Guide

I. Before Getting Started

  • Safety Regulations
  • Design Inspiration

II. Start

  • Lazervida - Assembly and Start-up
  • Lazervida - Laser Alignment
  • Lazervida - Stands Installation
  • Lazervida - How to update the firmware
  • Lazervida - How to thread the belts into the Y-axis slide rails

III. Software Operation

  • Laser Software Tutorial - Swiftray
  • Laser Software Tutorial - LaserGRBL
  • Laser Software Tutorial - Lightburn
  • Swiftray - How to change language settings
  • Swiftray - Unable to Open Software Properly
  • Swiftray - Bitmap files and vector files
See all 8 articles

IV. Maintenance

  • Lazervida - Laser Head Cleaning
  • Lazervida - Lubricating

V. Troubleshooting

  • Lazervida - Material cannot be cut through
  • Lazervida - Engraving and Cutting - Segment Jitter
  • Lazervida - Stop functioning during Engraving / Cutting 
  • Lazervida - Failing to Home
  • Lazervida - Rail Parallelism Adjustment
  • Lazervida - LED Power Button - Signal Light Identification
See all 13 articles

VI. Warranty

  • Warranty

VII. Disclaimer

  • Disclaimer

VIII. Add-on Modules

  • Lazervida - Rotary Add-on
  • Lazervida - Air Assist Add-on
  • Lazervida - Shield

IV. Maintenance

  • Lazervida - Replacing the Power Button
  • Lazervida - Replacing the Power Cable (3 Pin-Mainboard 4 Pin-Power button)
  • Lazervida - Replacing the Laser Head Seat
  • Lazervida - Replacing the Mainboard
  • Lazervida - Replacing the Y-Axis Limit Switch
  • Lazervida - Replacing the X-Axis Limit Switch Board
See all 7 articles
Lazervida Help Center
Japanese (Japan) 한국어(대한민국) 繁體中文